Specifications:

Operation:

• Connect motor cord into “Motor” socket
• For recharging, connect charger cord into the bottom socket then plug charger into wall outlet (green light will turn on)
• Required charging time is 4-6 hours and recharging is possible during operation
• Select rotation speed by “VR/HI” switch
  • “VR” switch = manual rotation speed from 1,700 ~ 20,000rpm
  • “HI” switch = automatic full rotation speed at 20,000 rpm only when full charged
• Select rotation direction either forward or reverse by “Forw/Rev” switch
• Turn knob right “ON” position for manual operation
• Select rotation speed between 1,500 rpm – 20,000 rpm by turning “Speed Control Knob”

Cautions:

• Never operate the handpiece without the bit.
• Never put oil into the handpiece.
• Don’t insert wet/oily bit into the handpiece.
• Operate with dry hands.
• Do not touch the plug, cord, switch, or handpiece with wet hands.
• Remove the cord from the plug socket after usage.
• Wear protective glasses while usage.
• Use the motor at the speed designated by the manufacturer or distributor.
• Start at the lowest speed and gradually increase speed as necessary.
• Do not used a bended, scratches or lopsided bit.
• The bit should be fully inserted in the chuck until the bit touches the innermost part.